Add-on kits CM-IO-B
To install and configure the peripheral devices of the add-on kits CM-IO-B, the CM-RC-02 must be connected in compressor operation mode and the CM-IO-B extension board must be installed.
All add-on lits kits must be activated in the BEST SOFTWARE after retrofitting.
Authorized staff
All work done on the products and the systems in which they are or will be installed may only be performed by qualified and authorised staff who have been trained and instructed in all work. The qualification and competence of the qualified staff must correspond to the local regulations and guidelines.
WARNING
The compressor is under pressure!
Serious injuries are possible.
Depressurise the compressor!
Wear safety goggles!
WARNING
Risk of electric shock!
Before working on the terminal box, module housing and electrical lines: Switch off the main switch and secure it against being switched on again!
Close the terminal box and the module housing before switching on again!
Attachments may be damaged!
Handle compressor, pre-assembled accessories, and cables with care.
- Only lift compressor by using the lifting eyes!
- Do not apply tension or pressure to protruding attachments.
- OLM-IQ-AS can protrude downwards. Support the compressor with feet when putting it down. Pay particular attention to this component!
