General safety references
For work on the compressor once it has been commissioned
WARNING
The compressor is under pressure!
Serious injuries are possible.
Depressurise the compressor!
Wear safety goggles!
DANGER
Life-threatening voltages inside the FI housing!
Contact can lead to serious injuries or death.
Never open the FI housing in operation!
Switch off the main switch and secure it against being switched on again.
Wait for at least 5 minutes until all capacitors have been discharged!
Before switching on again, close the FI housing.
CAUTION
Surface temperatures of more than 60°C or below 0°C.
Risk of burns or frostbite.
Close off accessible areas and mark them.
Before performing any work on the compressor: switch it off and let it cool down or warm up.
In case of subsequent mounting of the OLC-D1-S prism unit or after its replacement:
After incorrect mounting refrigerant or oil may escape. Before commissioning perform a tightness test!
Risk of damage to the component.
Tighten screws crosswise in at least 2 steps to the prescribed tightening torque.