Rinse the condenser
Step 4: Remove the upper grille
- 4 mm hexagon spanner
Step 5: Remove the fan
- 10 mm open-end ring ratchet wrench
Step 6: Rinse the condenser with water
NOTICE
If the water pressure is too high the condenser fins may be damaged!
If the water pressure is too high the condenser fins may be damaged!
The pressure of the water must not exceed 80 bar!
- Water
Step 7: Install the fan
- 10 mm open-end ring ratchet wrench
Information
Do the same with the second fan / the other condenser half!
Do the same with the second fan / the other condenser half!
Step 8: Clean up
- Rags or cloths